buy 1P-LSD Blotters


+ Free Shipping

buy 1P-LSD Blotters

buy 1P-LSD Blotters/ LSD (lysergic acid diethylamide) is a synthetic chemical, made from a substance found in ergot, which is a fungus that infects rye (grain).1

also, LSD belongs to a group of drugs known as psychedelics. When small doses are taken, it can produce mild changes in perception, mood and thought. Larger doses may produce visual hallucinations and distortions of space and time.

again, Sometimes, what is sold as LSD can actually be other chemicals such as NBOMe or the 2C family of drugs (part of the new psychoactive substances). further more, These can be quite dangerous, as their quality is inconsistent. Taking too much of these other substances can be fatal with a number of deaths having been reported

in addition, It is perhaps fair to consider that the synthesis[] and discovery of the psychoactive properties of d-lysergic acid diethylamide (LSD)[] (Figure 1) in 1943 triggered an avalanche of investigations that continue to capture the imagination of researchers across all disciplines.[3–10] conclusively, Although the pharmacology and properties of LSD have been investigated in many studies, major questions still remain unanswered and are expected to occupy the attention of researchers in the future.


Liquid chromatography electrospray mass spectrometry

LC-MS analyses were performed on an Agilent 1100 system. Separation was obtained on a Restek (Bellefonte, PA, USA) Allure PFPP column (5 µm, 50 × 2.1mm). Mobile phase A consisted of 0.1% formic acid in water, whereas, mobile phase B consisted of 0.1% formic acid in acetonitrile.

also, The Agilent LC-MSD settings were as follows: positive electrospray mode, capillary voltage 3500 V, drying gas (N2) 12 L/min at 350 °C, nebulizer gas (N2) pressure 50 psi, Scan mode m/z 70 – 500, fragment or voltage 150 V. again, The sample for LC-MS analysis was dissolved in acetonitrile/water (1:1, containing 0.1% formic acid) at a concentration of 10 µg/mL. The injection volume was 1 µL, flow rate was 0.80 mL/min and the column temperature was 30 °C. The total run time was 25 min. more over, The following gradient elution program was used: 0–2 min 2% B, followed by an increase to 60% within 15 min, then up to 80% within 20 min, returning to 2% within 25 min.


There is no safe level of drug use. Use of any drug always carries some risk. It’s important to be careful when taking any type of drug.

LSD can affect everyone differently, based on:

  • size, weight and health
  • whether the person is used to taking it
  • whether other drugs are taken around the same time
  • the amount taken
  • the strength of the drug (varies from batch to batch).

The effects of LSD usually begin in approximately 30 minutes and will last around 8-12 hours.5 The following may be experienced:

  • euphoria and wellbeing
  • dilation of pupils
  • perceptual changes, such as visual and auditory hallucinations.
  • confusion and trouble concentrating
  • headaches
  • nausea
  • fast or irregular heart beat
  • increased body temperature
  • breathing quickly
  • vomiting
  • facial flushes, sweating and chills.


There are no reviews yet.

Be the first to review “buy 1P-LSD Blotters”

Your email address will not be published. Required fields are marked *

Shopping Cart